Audio Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
When working on electronic components, make sure the work area is clean and dust free.
Make sure your hands are clean and free of oils and grease.
Eject the CD before disconnecting the audio unit to prevent damaging the CD player's load mechanism.
If you are replacing the audio unit, write down the audio presets (if possible), and enter them into the new audio unit.

2. Audio Unit Assembly - Remove
1.
Remove the bolts (B).

2.
Disconnect the hazard warning switch connector and the audio unit connectors, then pull out the audio unit assembly (C).
NOTE: There is a lever lock on audio unit connector A.

4. Audio Unit - Remove
1.
Remove the brackets (A) from the audio unit (B).

5. All Removed Parts - Install
1.
Install the audio unit in the reverse order of removal.
NOTE:
There is a lever lock on audio unit connector A.
Make sure all the connectors and the antenna lead are secure.
If the audio unit was replaced, enter the audio presets that you saved onto the new unit.