Front Door Panel Removal and Installation
2. Front Door Power Window Switch Panel - Remove
1.
Pry out on the notch (A) in the power window switch panel (B) with the trim tool.
2.
Disconnect the connectors (C), then remove the power window switch panel.

3. Front Door Panel - Remove
1.
Pry out on the upper hook (A) in the inner handle cap (B) with the trim tool, then pull back the inner handle cap.
2.
Remove the screws (A).
3.
Remove the pull pocket mat (A), then remove the screw (B).
4.
Starting at the bottom edge of the front door panel (A), detach the clips (B) with a commercially available trim pad remover.
5.
Starting at the rear, pull the front door panel up.
6.
Remove the inner handle (C) from the front door panel.
7.
For some models: Disconnect the connector (D).
8.
Remove the front door panel.

4. Front Door Inner Weatherstrip - Remove
1.
If necessary, remove the front door inner weatherstrip (A).

5. Front Door Armrest - Remove
1.
If necessary, remove the front door armrest (A).

6. Front Door Inner handle - Remove
1.
Detach the cable fasteners (A), then disconnect the latch cable (B) and the inner handle cable (C).

7. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: If the inner handle cable end is damaged or stress-whitened, replace it with a new one.