Rear Door Glass and Regulator Removal and Installation
2. Rear Door Plastic Cover - Remove
1.
Disconnect the connector (A), and detach the harness clips (B).
2.
Remove the screws (C), then remove the door pull pocket bracket (D).
3.
Remove the plug caps (E), then carefully remove the plastic cover (F).
NOTE: If the plastic cover is damaged or torn, replace it.

3. Rear Door Glass - Remove
1.
Lower the glass (A) until you can see the glass mounting bolts (B), then remove them.

2.
Carefully lower the glass into the door.
NOTE: Take care not to drop the glass inside the door.
3.
Remove the nut (A) and the bolt (B).
4.
Carefully pull out the glass (C) through the window slot.

NOTE: Take care not to drop the glass inside the door.

4. Rear Door Regulator - Remove
1.
Disconnect the connector (A).
2.
Remove the nut (C) and the bolts (D).
3.
Remove the rear door regulator through the hole in the door.

5. Rear Door Glass Run Channel - Remove

6. Rear Door Rear Lower Channel - Remove

7. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Apply multipurpose grease to all sliding surfaces of the rear door regulator (A) where shown.