Front Stabilizer Link Removal and Installation
3. Stabilizer Link - Remove
1.
Remove the flange nuts (A) while holding the respective joint pin (B) with a hex wrench (C).
2.
Remove the stabilizer link (D).

1. Stabilizer Link - Install
1.
Install the stabilizer link (A).
NOTE: The stabilizer link has a paint mark (B). Align the paint mark on the stabilizer link facing rearward.
2.
Install the flange nuts (C), and tighten them to the specified torque while holding the respective joint pin (D) with a hex wrench (E).

3. Test Drive - Check
1.
Test-drive the vehicle.
2.
After 5 minutes of driving, tighten the flange nut again to the specified torque.