Steering Angle Sensor Removal and Installation

SRS components are located in this area. Review the SRS component locations, and the precautions and procedures before doing repairs or service.

3. Cable Reel/Steering Angle Sensor - Remove
1.
Disconnect the connectors (A).
2.
Remove the cable reel/steering angle sensor (A).

4. Steering Angle Sensor - Remove
1.
Remove the steering angle sensor (A) from the cable reel (B).
NOTE:
INOTE: If reinstalling these removed parts later, make sure to keep the position of the rotating parts unchanged to reinstall them correctly.
During installation, position the two tabs (C) of the steering angle sensor as shown.

5. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.