Rear Differential Fluid Inspection and Replacement
2. Rear Differential Fluid - Check


1.
Use solvent and a brush to wash any oil and dirt off the oil filler plug, and dry them with compressed air.

2.
Remove the oil filler plug (A) and the sealing washer (B).

3.
Check the condition of the rear differential fluid, if the fluid is dirty or burnt, replace it.

4.
Make sure the rear differential fluid is at the proper level (C).

If the level is below the proper level, check for rear differential fluid leaks at the differential.
If a problem is found, fix it before filling the differential with fluid.

5.
The fluid level must reach up to the bottom of the oil filler plug hole.

6.
If necessary, add the rear differential fluid until it runs out, then reinstall the oil filler plug with a new sealing washer.

2. Rear Differential Fluid - Drain

1.
Remove the oil filler plug (A) and the sealing washer (B).





2.
Remove the drain plug (A) and the sealing washer (B), then drain the rear differential fluid.

3. Rear Differential Fluid - Refill


1.
Clean the drain plug (A).

2.
Install the drain plug with a new sealing washer (B).

3.
Refill the rear differential with rear differential fluid to the proper level.

NOTE: If you disassemble the differential, check the rear differential fluid level again after the 4WD system check is finished. Add fluid if necessary.

Fluid Capacity:
 
1.2 L (1.3 US qt, 1.1 Imp qt) at fluid change
 
1.4 L (1.5 US qt, 1.2 Imp qt) at overhaul

Recommended fluid:
 
Honda DPSF-II





4.
Install the oil filler plug (A) with a new sealing washer (B).

4. Maintenance Minder - Reset

1.
If the Maintenance Minder required to replace the rear differential fluid, reset the Maintenance Minder with the gauge. If the Maintenance Minder did not require to replace the rear differential fluid, reset the Maintenance Minder with the HDS.