LDW OFF Switch Removal, Installation, and Test
4. LDW OFF Switch - Remove


5. All Removed Parts - Install

1.
Install the parts in the reverse order of removal.

1. LDW OFF Switch - Test

1.
On the switch side, measure the resistance between the LDW OFF switch 5P connector terminals No. 2 and No. 5 according to the table.

If there is no resistance in one or more positions, replace the LDW OFF switch.

Position
Resistance
PRESSED
About 3.5 k?
RELEASED
About 13.5 k?





2.
Check the LED for illumination by applying power and ground to the terminals according to the table.

NOTE: This important operating characteristic; diode bias cause a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

If the results are not as specified, replace the LDW OFF switch.





3.
Check the LED for illumination by applying power and ground to the terminals according to the table.

NOTE: This important operating characteristic; diode bias cause a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).

If the results are not as specified, replace the LDW OFF switch.