DTC Troubleshooting: B1775
DTC B1775: Microphone Input/Output Shorted to Power or Open
NOTE:
1.
Problem verification:

Problem verification
?1.

Is DTC B1775 indicated?

     
YES
     
     
     
The failure is duplicated, go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time.?
2.
Shorted wire check (MIC+ line to power):

Shorted wire check (MIC+ line to power)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connectors.
HandsFreeLink control unit 32P connector
HFL microphone 10P connector

?3.
Turn the vehicle to the ON mode.

?4.
Measure the voltage between test points 1 and 2.
Test condition
Vehicle ON mode
 
HandsFreeLink control unit 32P connector: disconnected
 
HFL microphone 10P connector: disconnected
Test point 1
Test point 2
Body ground

Is there any voltage?

     
YES
     
     
     
There is a short to power in the wire between the HandsFreeLink control unit and the HFL microphone. Replace the affected shielded harness.?
     
NO
     
     
     
The MIC+ wire is not shorted to power. Go to step 3.
3.
Open wire check (MIC+ line, MIC? line):

Open wire check (MIC+ line, MIC? line)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
HandsFreeLink control unit 32P connector: disconnected
 
HFL microphone 10P connector: disconnected
Test point 1
Test point 2


Is there continuity?

     
YES
     
     
     
The MIC+ and the MIC? wires are OK. Go to step 4.
     
NO
     
     
     
There is an open in the wire(s) between the HandsFreeLink control unit and the HFL microphone. Replace the affected shielded harness.?
4.
HFL microphone check (substitution):

HFL microphone check (substitution)
?1.

?2.
Reconnect all the connectors.

?3.

Is DTC B1775 indicated?

     
YES
     
     
     
     
NO