|
How to Troubleshoot the EPS
System Indicator
This system has one (without LKAS (Lane Keep Assist System)) or two (with LKAS) indicators.
EPS Indicator
Under normal conditions, the EPS indicator comes on when turning the vehicle to the ON mode, then goes off after the engine is started. This indicates that the LED and its circuit are operating correctly. If there is a failure in the system after the engine is started, the EPS indicator will stay on, and the power assist is turned off or restricted. When the EPS indicator comes on, the control unit stores the DTC. In this case, the control unit will not activate the EPS system after the engine starts again, but it keeps the EPS indicator on. The EPS indicator will stay on until the DTC is erased. When a problem is detected and the EPS indicator comes on, there are cases when the indicator stays on until turning the vehicle to the OFF (LOCK) mode, and cases when the indicator goes off automatically when the system returns to normal. Even though the system is operating normally, the EPS indicator will come on under some conditions with the vehicle stopped and the engine at high speed with constant input from the steering wheel. To determine the actual cause of the problem, question the customer about the conditions during which the problem occured, taking the above conditions into consideration. LKAS (Lane Keep Assist System) Indicator
This EPS system is added to the LKAS. When an LKAS related problem is detected, LKAS indicator (amber) will come on. However, when the EPS control fails while the LKAS control is activated, LKAS indicator (amber) will also come on. In this case, EPS indicator will not come on, but the EPS control unit memorizes the DTC. If the LKAS indicator (amber) comes on, it deactivates the LKAS control. The power assist works as usual after deactivating LKAS, but it may stop the power assist depending on the detected malfunction. Diagnostic Trouble Code (DTC)
Self-Diagnosis
Self-diagnosis can be classified into three categories:
Restriction on Power Assist Operation
Repeated extreme steering force, such as turning the steering wheel continuously back-and-forth with the vehicle stopped, causes an increase in electrical current draw by the EPS motor. The increase of electric current causes the EPS motor and EPS control unit to heat up. Because this heat adversely affects the system, the control unit monitors the electric current draw of the EPS motor. When the control unit detects heat build-up in the EPS motor, it reduces the electric current to the EPS motor gradually to protect the system, and it restricts the power assist operation. The EPS indicator does not come on during this function. When steering torque is not applied to the steering wheel, or when turning the vehicle to the OFF (LOCK) mode and the EPS motor cools, the control unit will restore the power assist gradually until it's fully restored (after about 10 minutes). Steering Angle Sensor Neutral Position
The EPS control unit stores the steering angle sensor neutral position in the EEPROM. Do the steering angle sensor neutral position clear whenever you do any of these actions:
How to Troubleshoot DTCs
The troubleshooting procedures assume that the cause of the problem is still present and the EPS indicator is still on. Following the procedure when the EPS indicator does not come on can result in incorrect diagnosis.
How to Use the HDS (Honda Diagnostic System)
NOTE: Make sure the 12 volt battery is in good condition and fully charged.
NOTE:
How to Retrieve DTCs
How to Clear DTCs
|
