DTC Troubleshooting: B12D0
DTC B12D0: Power Control Unit IG1A Circuit Error
DTC Description
DTC
B12D0 Power control unit IG1A circuit error
 

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A.

NOTE: Make sure aftermarket accessories are not installed.

1.
Problem verification:

Problem verification
?1.
Clear the DTCs with the HDS.


?2.
Turn the vehicle to the ON mode.

?3.
Wait 10 seconds.

?4.
Turn the vehicle to the OFF (LOCK) mode.

?5.
Wait 5 seconds.

?6.
Check for DTCs with the HDS.
DTC Description
DTC
B12D0 Power control unit IG1A circuit error
 

Is DTC B12D0 indicated?

     
YES
     
     
     
Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for loose or poor connections.?
2.
Determine possible failure area (IG1A relay circuit ON problem, IG1A relay circuit OFF problem):

Determine possible failure area (IG1A relay circuit ON problem, IG1A relay circuit OFF problem)
?1.
Turn the vehicle to the ON mode.

?2.
Check the parameter(s) below with the HDS.
Signal
Current conditions
Value
Unit
IG1A
   

?3.
Check the IG1A with the HDS.

Is there battery voltage?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
Go to step 4.
3.
Under-dash subrelay box test (IG1A relay circuit):

Under-dash subrelay box test (IG1A relay circuit)
?1.

Is IG1A relay circuit OK?

     
YES
     
     
     
Repair a short to power in the wire.?
     
NO
     
     
     
Faulty IG1A relay circuit, replace the under-dash subrelay box.?
4.
Under-dash subrelay box test (IG1A relay circuit):

Under-dash subrelay box test (IG1A relay circuit)
?1.

Is IG1A relay circuit OK?

     
YES
     
     
     
Repair an open or high resistance in the wire.?
     
NO
     
     
     
Faulty IG1A relay circuit, replace the under-dash subrelay box.?