Audio Remote/Multi-Information Display Switch Removal, Installation, and Test

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

5. Audio Remote/Multi-Information Display Switch - Remove
1.
Remove the screw.
2.
Disconnect the connector.
3.
Remove the audio remote/multi-information display switch.

6. All Removed Parts - Install
1.
Install the audio remote/multi-Information display switch in the reverse order of removal.

1. Audio Remote/Multi-Information Display Switch - Test
1.
Measure the resistance between the terminals No. 2 and No. 5 in each switch position according to the table.
Position
Resistance
No button pressed
About 10 k?
SOURCE
About 3.7 k?
Right (CH ?)
About 1.7 k?
Left (CH ?)
About 775 ?
? (VOL.UP)
About 357 ?
? (VOL.DOWN)
About 99 ?
2.
Measure the resistance between the terminals No. 3 and No. 5 in each switch position according to the table.
Position
Resistance
MENU
About 33 ?
DISP
About 363 ?
3.
If the resistance is not as specified, replace the audio remote/multi-information display switch.