Rear Door Panel Removal and Installation
1. Rear Door Power Window Switch Panel - Remove
1.
Pry out on the notch (A) in the power window switch panel (B) with the trim tool.
2.
Disconnect the connector (C), then remove the power window switch panel.

2. Rear Door Panel - Remove
1.
Remove the rear door quarter inner trim (A).
2.
Pry out on the upper hook (A) in the inner handle cap (B) with the trim tool, then pull back the inner handle cap.
3.
Remove the screws (A).
4.
Remove the pull pocket mat (A), then remove the screw (B).
5.
Starting at the bottom edge of the rear door panel (A), detach the clips (B) with a commercially available trim pad remover.
6.
Starting at the rear, pull the rear door panel up.
7.
Remove the inner handle (C) from the rear door panel.
8.
Remove the rear door panel.

3. Rear Door Inner Weatherstrip - Remove
1.
If necessary, remove the rear door inner weatherstrip (A).

4. Rear Door Armrest - Remove
1.
If necessary, remove the rear door armrest (A).

5. Rear Door Inner Handle - Remove
1.
Detach the cable fasteners (A), then disconnect the latch cable (B) and the inner handle cable (C).

6. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: If the inner handle cable end is damaged or stress-whitened, replace it with a new one.