Carefully push on the top edge of the mirror holder (A) by hand.
2.
Put a shop towel in the opening between the bottom edge of the mirror holder and the mirror housing (B) to prevent scratches.
3.
Insert a flat-tip screwdriver under the mirror holder, and quickly twist the screwdriver to release the hook (C).
4.
Apply heat with a heat gun to the gap between the mirror holder (A) and the mirror housing (B). Carefully pull out the bottom edge of the mirror holder to separate the adhesive (C).
NOTE: Do not heat the plastic parts too much or you may damage them.
5.
Separate the mirror holder from the actuator (D).
6.
With power mirror defogger: Disconnect the connectors (E).
2.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE: Before reinstalling the mirror holder to the actuator (A), check the actuator rods (B) and the actuator boots (C) as shown.
