Transmission Range Switch Removal and Installation
2. SCS - Short
1.
Turn the vehicle to the OFF (LOCK) mode.
2.
Jump the SCS line with the HDS, and wait more than 1 minute.

6. PCM with Bracket - Remove

2.
Remove the harness clamps (B) and the harness holder (C).
3.
Remove the PCM (D) with the bracket.

7. 12 Volt Battery Base - Remove
1.
Remove the harness clamps (A).
2.
Remove the battery base (B).
NOTE: Loosen the bolts (C), without removing them.

8. Engine Wire Harness - Remove
1.
Remove the harness clamps (A).
2.
Remove the harness holder.
3.
Remove the harness holder.

9. Transmission Range Switch Connector - Disconnect

10. Transmission Range Switch - Remove
1.
Apply the parking brake.
2.
Shift the transmission to N position/mode.
3.
Remove the control shaft cover (A).
4.
Remove the transmission range switch (B).

1. Transmission Range Switch - Install
1.
Make sure the control lever (A) is in the N position. If necessary, move the control lever to the N position.
NOTE: Do not use the control shaft (B) to adjust the shift position. If the control shaft tips are squeezed together it will cause a faulty signal or position due to play between the control shaft and the transmission range switch.
2.
Set the transmission range switch (A) to the N position. Align the cutouts (B) on the rotary-frame with the N positioning cutouts (C) on the transmission range switch, then put a 2.0 mm (0.079 in) feeler gauge (D) in the cutouts to hold the transmission range switch in the N position.
NOTE: Be sure to use a 2.0 mm (0.079 in) feeler gauge or equivalent to hold the transmission range switch in the N position.
3.
Install the transmission range switch (A) gently on the selector control shaft (B) while holding it in the N position with the 2.0 mm (0.079 in) feeler gauge (C).
4.
Loosely install the bolts (D).
5.
Tighten the bolts (A) on the transmission range switch (B) while you continue holding the N position.
NOTE: Do not move the transmission range switch when tightening the bolts.
6.
Remove the feeler gauge (C).
7.
Install the selector control shaft cover (D).
8.
Shift the transmission to P position/mode.

2. Transmission Range Switch Connector - Connect
NOTE: Check the connector for corrosion, dirt, or oil, and clean or repair if necessary.


3. Engine Wire Harness - Install
1.
Install the harness holder.
2.
Install the harness holder.
3.
Install the harness clamps (A).

4. 12 Volt Battery Base - Install
1.
Install the battery base (A).
2.
Install the harness clamps (B).

5. PCM - Install
1.
Install the PCM (A) with the bracket.
2.
Install the harness holder (B) and the harness clamps (C).


9. Transmission Range Switch - After Install Check
1.
Apply the parking brake.

2.
Turn the vehicle to the ON mode.
3.
Shift the transmission to each position/mode, and check that the A/T gear position indicator follows the shift lever operation.
4.
Start the engine.
NOTE: Check that the engine starts in P or N position/mode, and does not start in any other positions/modes.
5.
Check that the back-up lights come on when the transmission is in R position/mode.
6.
Shift the transmission to P position/mode.
7.
Turn the vehicle to the OFF (LOCK) mode. When cannot it, adjust the shift cable.