DTC Troubleshooting: P0117
DTC P0117: ECT Sensor 1 Circuit Low Voltage
NOTE: Before you troubleshoot, review the general troubleshooting information.

DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P0117 ECT Sensor 1 Circuit Low Voltage
     

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
ECT SENSOR 1
Less than 0.08
V
    

Do the current condition(s) match the threshold?

     
YES
     
     
     
The failure is duplicated. Go to step 2.
     
NO
     
     
     
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at ECT sensor 1 and the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?
2.
ECT sensor 1 performance check:

ECT sensor 1 performance check
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Disconnect the following connector.
ECT sensor 1 2P connector

?3.
Turn the vehicle to the ON mode.

?4.
Check the parameter(s) below with the HDS.
Signal
Threshold
Current conditions
Values
Unit
Values
Unit
ECT SENSOR 1
Less than 0.08
V
    

Do the current condition(s) match the threshold?

     
YES
     
     
     
Go to step 3.
     
NO
     
     
     
3.
Shorted wire check (TW line):

Shorted wire check (TW line)
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Jump the SCS line with the HDS, and wait more than 1 minute.


?3.
Disconnect the following connector.
PCM connector B (51P)

?4.
Check for continuity between test points 1 and 2.
Test condition
Vehicle OFF (LOCK) mode
 
ECT sensor 1 2P connector: disconnected
 
PCM connector B (51P): disconnected
Test point 1
ECT sensor 1 2P connector No. 2
Test point 2
Body ground


Is there continuity?

     
YES
     
     
     
Repair a short in the TW wire between the PCM (B50) and ECT sensor 1.?
     
NO
     
     
     
The TW wire is OK. Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If DTC P0117 goes away and the PCM was updated, troubleshooting is complete. If DTC P0117 goes away and the PCM was substituted, replace the original PCM.?