Keyless/Power Door Locks/Security System Symptom Troubleshooting - Doors will not unlock (or lock) with the transmitter, but will unlock (or lock) with the door lock switch and the door key cylinder switch
Doors will not unlock (or lock) with the transmitter, but will unlock (or lock) with the door lock switch and the door key cylinder switch
NOTE: Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, troubleshoot the indicated DTC first.

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the OFF (LOCK) mode.

?2.
Remove the ignition key from the ignition switch.

?3.
Close all the doors.

?4.
Try to lock/unlock the doors with the keyless transmitter.

Do the door lock actuators work normally?

     
YES
     
     
     
Intermittent failure, the system is OK at this time.?
     
NO
     
     
     
Go to step 2.
2.
Determine possible failure area (ignition switch or ignition switch wire, others):

Determine possible failure area (ignition switch or ignition switch wire, others)
?1.
Open the driver's door.

Does the key-in reminder chime sound?

     
YES
     
     
     
     
YES
     
     
     
Short to ground on the related ignition switch wire. Repair the wire as needed.?
     
NO
     
     
     
Go to step 3.
3.
Transmitter check:

Transmitter check
?1.

Is the transmitter OK?

     
YES
     
     
     
Go to step 4.
     
NO
     
     
     
Replace the transmitter, then register the new transmitter.?
4.
Under-dash fuse/relay box check (substitution):

Under-dash fuse/relay box check (substitution)
?1.
Substitute a known-good under-dash fuse/relay box.

?2.
Recheck the system.

Is the system normal?

     
YES
     
     
     
     
NO