Multi-Information Display Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
When working on electronic components, make sure the work area is clean and dust free.
Make sure your hands are clean and free of oils and grease.

4. Multi-Information Display Unit Assembly - Remove
1.
Pull out the multi-information display unit assembly (A).
2.
Disconnect the connectors (B).

6. Multi-Information Display Unit - Remove

7. All Removed Parts - Install
1.
Install the multi-information display unit in the reverse order of removal.
NOTE:
After installing the audio-navigation unit, park the vehicle outside, and do the GPS initialization.
When the audio-navigation unit is disconnected, do the Map Matching. This part of the initialization matches the GPS coordinates with a road on the map screen. To do this part of the procedure, make sure that the navigation system displays a map, and drive the vehicle on a mapped road shown on the map screen. Do not enter a destination at this time. When the name of the current road you are driving on appears at the bottom of the screen, the entire procedure is complete.